221
To Select a Portion of Several Clips
1. Press and hold the Alt key.
2. Drag the mouse across part of several clips in adjacent tracks.
SONAR highlights the selected portions of all the clips. You can edit these portions
of clips using all the normal editing commands.
To Select Partial Clips Using Time Ranges and Tracks
1. Select a range of time in one of the following ways:
• Drag the mouse in the Time Ruler.
• Click between two markers to select the time between the markers.
• Use the F9 and F10 keys to set the beginning and end selection times.
• Select a clip (SONAR selects the range of time covered by the clip).
• Choose Edit-Select-By Time, enter the start and end time, and click OK.
2. Select one or more tracks by clicking, Shift-clicking, or Ctrl-clicking on the
track numbers in the Track view.
3. To adjust the start and end time of the selection, hold the Shift key while
clicking on the Time Ruler.
The relevant portions of clips in the selected tracks are highlighted. You can edit
these portions of clips using all the normal editing commands.
To Clear the Partial Clip Selection
You can clear the time-restricted selection in any of the following ways:
• Click in an empty area of the Clips pane to completely clear the selection.
• Choose Edit-Select-None or press Ctrl+Shift+A to completely clear the
selection.
• Click on a single clip in the Clips pane to clear the time selection and select
the clip.
Markers and the Snap Grid
SONAR has a collection of features you can use to simplify and speed the work you
do arranging your projects. Here are a few of the most important things you can
do:
• Show gridlines on measure boundaries in the Track view.
• Define and use the Snap Grid to make drag-and-drop editing more accurate.
• Create markers to identify and work with key time points in your project.
To Next Page
Loading...