433
You control the mixing and playback of an audio track as follows:
SONAR displays volume in dB (decibels). When adjusting the volume or bus send
level controls, a value of 0 dB indicates full signal strength; positive values, up to 6
dB, indicate a signal gain; negative values indicate an attenuated signal. When
you move the Pan control, the Value box displays the pan value on a scale that
ranges from 100%L (hard left) 100%R (hard right).
To do this... Do this...
Add a real-time audio effect
to the track
Right-click in the Effects patch point and select an
effect from the list (for more information, see “Using
Real-Time Effects” later in the chapter)
Remove an effect Select the effect and press Delete or right-click and
select Delete.
Send audio data from the
track to a bus
Select the corresponding Bus Send Enable and set
the Bus Send Level (for more information, see “Stereo
Buses” on page 434”)
Mute the track Click the Mute button
Solo the track Click the Solo button
Arm the track for recording Click the Arm button
Set the Pan level Adjust the Pan control
Set the Volume level Adjust the Volume fader
Select the output Click the dropdown arrow in the Output field and
choose one from the list
Select the input Click the dropdown arrow in the Input field and choose
one from the list
To Next Page
Loading...