392
The parameters used to specify the chorus effect are as follows:
To Apply Delay to Audio Data
1. Select the audio data to be affected. Select a stereo pair for stereo delay.
2. Choose Audio Effects-Cakewalk-FxDelay from the Process menu or from
the popup menu to open the Cakewalk FxDelay dialog box.
3. Set the parameters in the dialog, as described in the table above.
4. Click OK.
SONAR applies the specified delay effect to the selected data.
Parameter/Option... Meaning...
Delay(ms)—coarse The delay time in milliseconds.
Delay(ms)—fine A fine tuning of the delay time.
Feedback The regeneration of the delay.
Pan Left/Right pan. 0 is center. -1 is hard left. 1 is hard
right.
Voice 1-4 Four separate delays. Bypass a voice by clicking the
on button above the voice’s selection button.
Global Controls all voices.
Mix Level The Wet/Dry mix of the output. If set all the way to the
left, the chorus has no effect on output. If set all the
way to the right eliminates all dry signal.
Output Level The output volume level.
Bypass The plug-ins bypass button.
To Next Page
Loading...