131
You can rearrange and resize the panes in the Track view as shown in the
following table:
You can customize which tracks are displayed or not displayed, and enlarge or
maximize individual tracks while other tracks remain minimized. You can also
manually set the exact size of a track’s display. The following table shows how to
customize the appearance of tracks in the Track pane:
You can display subsets of the Track pane’s controls by selecting one of the tabs
located at the bottom of the Track view. The following table lists the controls
displayed when each tab is selected:
To do this... Do this...
Change the size of the Track pane Drag to the left or right the divider that
separates the Track and Clips panes
Change the Size of the Mains/Buses
pane
Drag up or down the divider that separates
the Track and Clip panes from the Bus pane
To do this... Do this...
Maximize a track Click the Maximize button in the track
Restore a track to its default size Click the Restore button in the track
Minimize a track Click the Minimize button in the track
Change the default size of a track
using splitter bars
Move the cursor over the gap below a track
until the cursor looks like this . Click and
drag until the track is the size you want.
Tab Controls displayed when selected
All • All controls are displayed
Mix • Volume
•Pan
• Volume Trim
• Phase (audio tracks only)
• Key+ (MIDI tracks only)
• Time+ (MIDI tracks only)
To Next Page
Loading...