CAKEWALK SONAR - Page 243

243
To Change the Current Tempo in the Tempo Toolbar
1. Enable Groove clip Looping on any audio clips that you want to follow the
tempo changes. Do this by selecting one or more clips, right-clicking a selected
clip, and choosing Groove-Clip Looping from the popup menu. Each clip that
has Groove clip Looping enabled has beveled edges instead of sharp corners.
The same command disables Groove clip Looping on any selected clip that has
Groove clip Looping enabled.
2. Click the current tempo in the Tempo toolbar.
3. Type a new value and press Enter, or use the spinners to change the tempo
value.
SONAR changes the current tempo to the desired value.
To Set the Tempo Ratio
You can set the tempo ratio in several ways (remember, this function is not
available if you have audio clips in your project):
• Click one of the tempo ratio buttons.
• Choose Transport-Tempo Ratio 1, 2, or 3.
• Press Ctrl+1, Ctrl+2, or Ctrl+3.
SONAR changes the speed of playback.
To Change the Tempo Ratio
1. Shift-click one of the tempo ratio buttons to display the Tempo Ratio dialog
box.
2. Enter a new value for the tempo ratio.
3. Click OK.
From now on, that tempo ratio button uses the ratio you entered.