37
You can hide or show any of the Track/Bus Inspector’s controls, and use it to
display the controls from any track or bus. The following table shows you how:
To do this… Do this…
Hide or show the Track/Bus Inspector Press i on your keyboard.
Display a certain track’s or bus’s controls
in the Track/Bus Inspector
Click the track or bus to make it current, or
choose the track or bus in the track/bus
dropdown menu that’s at the bottom of the Track/
Bus Inspector.
Hide or show any of the Track/Bus
Inspector’s controls
Click any of the four buttons at the bottom of the
Track Inspector (these are 3-position buttons,
except for the Volume button):
• Send button —when yellow, displays
send controls for audio tracks and busses;
and channel, bank, and patch controls for
MIDI tracks. When blue, shows as many
sends as possible.
• Volume button —hides or shows the
volume fader in MIDI tracks, audio tracks,
and busses.
• EQ button —in audio tracks and busses
shows the built-in EQ controls. When yellow,
shows band 1; when blue, shows all 4
bands. In MIDI tracks it has no function.
• FX button —when yellow, shows the FX
bin in audio tracks and busses. When blue,
also shows the first 4 parameters of the
selected effect (if it’s an automatable effect).
In MIDI tracks, shows the FX bin when
yellow. When blue, shows sliders for 4
assignable MIDI continuous controllers.
Note: you can not display a MIDI track’s Time +
or Key + controls in the Track/Bus Inspector.
Reassign MIDI controller sliders in a MIDI
Track’s Fx bin
Right-click the slider you want to reassign and
choose Reassign Control from the popup menu,
choose the new parameter, and click OK.
Display the parameters of a different
automatable effect
Click the name of the effect you want to select.
Assign a control to a group, arm it for
automation, take an automation
snapshot, or set up remote control
Right-click the control and choose options from
the popup menu.
To Next Page
Loading...