431
passes through the track’s send level knob on its way to the bus. This is shown in
the diagram below:
The audio in each bus passes through the send level and pan controls, is processed
by any real-time effects you have patched, sent through the output level and pan
controls, and then sent to the designated main out, in stereo.
At each main out, all audio data from audio tracks and buses that were routed to
that main are mixed together. Finally, the data passes through each main’s master
volume fader
This track is routed to
Bus 1 and 2
Pre-fader: output level to Bus 2 is not
affected by the track’s volume fader
Post-fader: track’s volume fader
controls output level to Bus 1
To Next Page
Loading...