505
parameter is now set to hard right. Setting the pan in offset mode to 50% right
would set the pan to the center.
Note: Any position that you set a fader to in Offset mode remains in effect when
you switch back to Envelope mode. For example, if you set a volume fader to -INF
while in Offset mode, switch to Envelope mode and drag the fader to its maximum
level, you will not hear anything.
To Turn On Offset Mode
There are several ways to turn on Offset mode in SONAR:
• In the Track view toolbar or Console view toolbar, click the Offset button.
• In the Automation toolbar, click the Offset button.
• Press the o key.
In Offset mode, all controls that can be offset appear with a plus sign. For example
Vol+.
The following audio controls support both Envelope and Offset modes:
Control Envelope Mode Range Offset Mode Range
Volume -Infinity to +6dB, default is 0dB -Infinity to +6dB, default is 0dB
Pan 100% L to 100% R, default is C 100% L to 100% R, default is C
Bus Send Level -Infinity to +6dB, default is 0 dB -Infinity to +6dB, default is 0dB
Bus Send Pan 100% L to 100% R, default is C 100% L to 100% R, default is C
Bus Return
Level
-Infinity to +6dB, default is 0dB -Infinity to +6dB, default is 0dB
Bus Return
Balance
100% L to 100% R, default is C 100% L to 100% R, default is C
Main Out
Volume
-Infinity to +6dB, default is 0dB -Infinity to +6dB, default is 0dB
Main Out
Balance
100% L to 100% R, default is C 100% L to 100% R, default is C
To Next Page
Loading...