CAKEWALK SONAR - Page 522

522
9. If you want to save these key bindings for other sessions, make sure that the
Save Changes for Next Session checkbox is checked.
10. Click OK when you are done.
SONAR assigns the key(s) you chose.
To Create a Key Binding Using a MIDI Keyboard
1. Choose Options-Key Bindings to display the Key Bindings dialog.
2. Check MIDI in the Type of Keys list.
3. Check the Enable box to make sure MIDI key bindings are enabled.
4. If you haven’t already done so, create a key binding shift key by doing one of
the following:
• Check Key under MIDI Shift Options, and enter the name of the key you
want to use.
• Check Controller under MIDI Shift Options, and choose the controller you
want from the list.
5. Highlight the key you want to bind from the Key list (if you click inside the
Key window to put the focus on it, you can then play a note on your MIDI
keyboard, and the note automatically becomes highlighted in the Key
window).
6. Select the command you want to bind from the Function list.
7. Click the Bind button.
SONAR places an asterisk next to the Key that you chose, and draws a line
from the highlighted key to the command that it’s bound to. Any keys that are
assigned to commands have asterisks next to them. Any commands that have
keys assigned to them list the keys in the Computer column and/or the MIDI
column.
8. Repeat steps 5 through 7 for all the keys you want to bind.
9. If you want to save these key bindings for other sessions, make sure that the
Save Changes for Next Session checkbox is checked.
10. Click OK when you are done.
SONAR assigns the key(s) you chose.
To disable MIDI key bindings, uncheck the Enable box in the Key Bindings
dialog.