117
M4.0-1055-001
ELECTRICAL
Electrical
Electrical
The electrical system is powered by a 36 volt battery.
To provide battery power for the electrical controls of
the truck, the battery retainers must be in position, the
battery connector on the right side of the truck must be
engaged, operator in position in the operator compart-
ment and the keyswitch cycled from "off" to "start" to
"on." The controls are now ready for operation.
Smooth and effortless traction speed control is made
possible through the use of the multi-task control han-
dle, traction drive module (Access 3) and AC traction
motor. By moving the multi-task control handle forward
(away from operator) or reverse (toward operator), infi-
nite speed control is possible in relation to control lever
movement, from creep speed to maximum speed.
Lift, lower, steering, tilt and tilt position assist/measure-
ment, horn, sideshift and an accessory function are
controlled via the multi-task control handle, hydraulic
control module (AC or DC), pump motor (AC or DC)
and, when applicable, accessory control module (Ac-
cess 7). Solenoids provide the lockout means to permit
the function desired only to operate.
Crown 2007 PF15714-1
To Next Page
Loading...