65
M1.0-1055-070
01 Rev. 3/07
LUBRICATION & ADJUSTMENT
Componentry
RPS1
Rotational Position Sensor 1
Location: bottom side of floorboard.
Purpose: provides input to the Access 3 for braking
command.
Data: 0.5 - 4.5VDC.
Adjustment: none required.
RPS2
Rotational Position Sensor 2
Location: right hand side of tilt cylinder.
Purpose: provides input to Access 7 for tilt cylinder po-
sition.
Data: 0.5 - 4.5VDC.
Adjustment: none required.
RS
Reverse Switch
Location: multi-task handle.
Purpose: informs control system reverse travel being
requested by operator.
Data: optic switch output 0 volt when reverse travel di-
rection selected. Output 5 volt when in neutral or for-
ward travel selected.
Adjustment: none required.
Figure 15929
Figure 15930
Figure 15931
Crown 2007 PF15674-21 Rev. 3/07
To Next Page
Loading...