135
M4.3-1055-003
04 Rev. 10/09
ELECTRICAL
ACCESS 123...System
Hours - Message Mode
This menu allows the operator to display accumulated
hours. To select this message, power up the truck.
Press the right arrow. Use the up/down arrows, scroll
to Hours. Press the enter/return button. The display will
exit the Message Mode and show (H1 or H2 = XX). H1
or H2 hours can be shown depending on which hour
meter is selected in Features menu F25 Hour Meter.
For information on the difference between H1 and H2
meters, refer to “Hour” (follows after “Odometer - Mes-
sage Mode”).
Odometer - Message Mode
Press the right arrow. Use the up/down arrows to scroll
to Odometer. Press the enter/return button. The dis-
play will exit the Message Mode and show the distance
the truck has traveled, in miles (mi=XX).
Hour
This menu allows the operator to view one of nine dif-
ferent hour meter readings.
• H1 (key switch on, operator in compartment)
• H2 (key switch on, operator in compartment plus
programmable timeout which will increment for the
timeout period after operator has left the compart-
ment)
• H3 (odometer)
• H4 (ACCESS 3 (TCM) on time)
• H5 (ACCESS 2 (HCM) on time)
• H6 (ACCESS 1 (DCM) value)
• H7 (ACCESS 2 (HCM) value)
• H8 (ACCESS 3 (TCM) value)
• H9 (ACCESS 7 (ACM) value)
To enter this menu, power up the truck. Press the down
arrow to display Hour. Press the right arrow, H1 will be
displayed. Use the up/down arrows to view different
hour meter readings. To stop the message from scroll-
ing press the right arrow at the desired hour meter. To
exit Hour menu press the left arrow until Hour is dis-
played.
Pressure
On trucks that are equipped with an accessory with a
pressure regulator (like a carton clamp), this menu al-
lows the operator to set the pressure for the attach-
ment. To view/use this menu, the truck must be
equipped with PVAR and features menus F20 Pres-
sure Regulator must be enabled.
Events
This menu allows the operator to view stored event
codes (up to 16). To enter this menu, power up the
truck. Press the down arrow until Events is displayed.
Press the right arrow, Last will briefly be displayed. The
last event code stored will then be displayed
(EV=XXX). Use the up/down arrows to scroll through
stored event codes (Last to Last-15). Press the left ar-
row button to return to the main menu at Events.
Note: Event codes can not be cleared from the Opera-
tor level menu.
Crown 2007 PF15628-3 Rev. 10/09
To Next Page
Loading...