LUBRICATION & ADJUSTMENT
Componentry
46
M1.0-1055-051
Access 7
Accessory Control Module (ACM)
Location: top of power unit, below multifunction con-
trol handle.
Purpose: controls solenoid valve actuations.
Data: information received from truck accesses, multi-
task handle and sensors.
Adjustment: none required.
ALM1
Status Alarm
Location: distribution panel.
Purpose: audible warning when operator does incor-
rect sequence (SRO). Also sounded when foot on entry
bar.
Data: controlled by Access 1.
Adjustment: none required.
ALM2
Travel Alarm
Location: chassis, above oil filter (left side).
Purpose: audible warning when truck is traveling for-
ward and/or reverse direction.
Data: controlled by Access 2.
Adjustment: none required.
BRESL, BRESR
Battery Restraint Switches
Location: cubbies on left/right sides.
Purpose: monitor switch for control system. Informs
control system when battery restraints are in place.
Data: wired normally open - held closed when battery
door is in place.
Adjustment: none required.
Figure 15861
Figure 16196
Figure 15900
Figure 15866
Crown 2007 PF15674-2
To Next Page
Loading...