365
M8.9-1055-003
CYLINDERS
Sideshifter Cylinder
Sideshifter Cylinder Disassembly
Do not clamp over the cylinder shell.
1. Clamp the cylinder assembly in a soft-jawed vise,
as shown in Figure 15969.
2. Carefully center the cylinder rod and remove the
spiral snap rings from the retainers.
Extreme care should be taken to prevent damage to
cylinder wall and ram assembly.
3. Ease the retainers into the shell approximately
50.0 mm (2.0 in). Pry one end of each retaining
ring up and remove it from the groove, as shown in
Figure 15971.
A pair of special tools can be used to facilitate packing
removal (Refer to Figure 15963).
Figure 15969
1 Cylinder Assembly
2 Cylinder Rod
3 Spiral Snap Rings
Figure 15971
Figure 15963
1 Screwdriver
152.0 mm (6.0 in) Shaft Length (Min.)
4.0 mm (0.156 in) Shaft Diameter (Max.)
2 No. 8 Metal Screw Headless (4.0 mm Self-Tapping)
3 Weld (Grind Off Excess) to a Max. Dia. of 4.0 mm (0.156 in)
4 Tape
Crown 2007 PF15684-3
To Next Page
Loading...