LUBRICATION & ADJUSTMENT
Componentry
64
M1.0-1055-069
01 Rev. 3/07
P
Pump Contactor
Location: horizontal on contactor panel.
Purpose: switch power to Access 2. On/off controlled
by Access 2 via operator input.
Data: 36VDC.
Adjustment: none required.
PT1
Load Sense
Location: bottom side of mast mounted manifold.
Purpose: provides approximate weight measurement
information on forks for data capacity monitor.
Data: bi-directional differential pressure transducer.
Adjustment: none required.
PRVA
Clamp Pressure
Location: mast.
Purpose: replaces RVA valve when truck equipped
with pressure regulator option.
Data: 24VDC maximum.
Adjustment: none required.
Figure 15924
Figure 15925
Figure 15927
Crown 2007 PF15674-20 Rev. 3/07
To Next Page
Loading...