207
M4.6-1055-005
ELECTRICAL
Battery
Battery Installation
Don't allow any metallic objects to come in contact with
the top of the battery cells. This may cause a short cir-
cuit when removing, installing or transporting the bat-
tery. Use an insulator (such as plywood) to cover the
top of the battery before and during removal and instal-
lation.
1. Check to be sure key switch is turned off.
2. Remove battery retainer (one side only).
3. Position battery roller stand next to truck. Align
stand with battery compartment. Battery roller
stand should be the same height as the truck's bat-
tery compartment rollers and as long as or longer
than battery.
Figure 16007
Figure 16008
Crown 2007 PF15687-5
To Next Page
Loading...