ELECTRICAL
Event Code 717
272
M4.8-1055-062
03 Rev. 10/09
Event Code 717
Excessive Current SVA1A Solenoid Coil Circuit.
Event logged if excessive current flows through driver
CA230-7.
Step 1: Remove wire from CA230-7. Key on truck and
attempt to SS right, monitor event code.
• If: Event 717 is not the last event.
– Then short is in the wiring or solenoid. Coil re-
sistance should be approximately 39 ohms.
Reinstall wire and proceed to Step 2.
• If: Event 717 is still the last event.
– Then replace ACCESS 7.
Step 2: Remove positive wire from solenoid. Key on
truck and attempt to SS, monitor event code.
• If: Event 717 is still the last event.
– Then short exists in wiring, check for shorts be-
tween negative and positive wire.
• If: Event 717 is not the last event code.
– Then short exists in solenoid, replace solenoid.
Coil resistance should be approximately 39
ohms.
Event Code 718
Excessive Current SVA1B Solenoid Coil Circuit.
Event logged if excessive current flows through driver
CA230-8.
Step 1: Remove wire from CA230-8. Key on truck and
attempt to SS left, monitor event code.
• If: Event 718 is not the last event.
– Then short is in the wiring or solenoid. Coil re-
sistance should be approximately 39 ohms.
Reinstall wire and proceed to Step 2.
• If: Event 718 is still the last event.
– Then replace ACCESS 7.
Step 2: Remove positive wire from solenoid. Key on
truck and attempt to SS, monitor event code.
• If: Event 718 is still the last event.
– Then short exists in wiring, check for shorts be-
tween negative and positive wire.
• If: Event 718 is not the last event code.
– Then short exists in solenoid. Coil resistance
should be approximately 39 ohms. Replace the
solenoid.
Figure 16069 Figure 16070
Crown 2007 PF15665-62 Rev. 10/09
To Next Page
Loading...