STEERING
Steering
310
M6.0-1055-002
Steer Command Assembly
Refer to the following procedures and Figure 16181 to
assemble the Steer Command Assembly.
1. Slide retaining ring (index 10) onto tiller mount (in-
dex 12).
2. Slide flatwasher (index 9), ball bearing sensor (In-
dex 8) and O-ring (index 7) onto tiller mount. Slide
retaining ring (index 6) on tiller mount and snap into
place.
3. Assemble steer control unit to tiller support using
two screws (index 5). Snap retaining ring (index
10) into place. Slide tiller mount (index 12) into
steer control unit.
4. Assemble steer knob (index 17) to tiller using one
roll pin (index 16), one lockwasher (index 14) and
one screw (index 13).
5. Assemble mounting plate (index 3) to tiller support
(index 4) using three flatwashers (index 2) and
three screws (index 1).
6. Assemble tiller mount to tiller (index 15) using two
screws (index 11).
7. Assemble steer control unit, tiller support and
mounting plate to truck frame using three flatwash-
ers (index 2) and three screws (index 1).
Figure 16181
(1)
Steer Control Unit
(2)
Part of Top of Truck Frame
Crown 2007 PF15713-2
To Next Page
Loading...