27
M1.0-1960-500
01 Rev. 6/08
LUBRICATION & ADJUSTMENT
Lubrication and Adjustment
Lubrication and Adjustment
To obtain maximum life of any industrial equipment, a
well planned maintenance program (PM), performed
by qualified technical personnel should be followed. In
conjunction with, and an integral part of, any planned
maintenance program should be daily operator input.
Operator involvement can greatly reduce truck down
time, assist in determining planned maintenance (PM)
schedules and ultimately save money. For these rea-
sons, Crown recommends a checklist similar to the Op-
erators Daily Checklist shown below.
Before performing maintenance to any unit, it should
be taken to an area set aside for maintenance or a sec-
tion where there is adequate space to perform required
work. This is a must to insure the safety of others and
to insure that proper maintenance is performed to the
unit.
If desired, padded packs of this checklist (OF-3772)
are available through your Crown dealer.
Figure 14990
Crown 2007 PF15686-1 Rev. 6/08
To Next Page
Loading...