ELECTRICAL
Contactor
202
M4.4-1055-002
Contact Replacement
1. Remove electrical connections to contacts (coils
do not have to be disconnected for this procedure).
2. Remove two screws (Index 5) from top of contacts
and lift contact assembly from truck.
3. Disassemble and replace contacts.
4. Install contact assembly on coils and fasten se-
curely with two screws (Index 5).
5. Connect cables.
Coil Replacement
1. Disconnect all electrical wiring.
2. Remove the four contactor mounting screws and
remove contactor from truck.
3. Remove two screws (Index 5) and separate con-
tact assembly from coil assembly.
4. Select replacement coil and transfer plunger (In-
dex 9) from coil being replaced to replacement coil.
5. Reassemble contact assembly to coil assembly
and secure with two screws (Index 5).
6. Mount contactor on truck and reconnect all electri-
cal wiring.
Crown 2006 PF15387-2
To Next Page
Loading...