327
M7.0-1055-007
02 Rev. 5/08
LIFTING MECHANISM
Mast
13. Install stop bolt to the bottom of inner stage. This
stop must be installed to the opposite side of mast
from lift hoses to prevent hose damage when the
mast is extended completely.
14. Install carriage cylinder into the inner mast using
U-bolt and two screws.
15. Install yoke assembly to the carriage cylinder and
connect chains and hydraulic lines to back of car-
riage.
Figure 15580
(1)
See Carriage Hydraulics - TT
(2)
See Mast - TT
(3)
See Mast Cylinder
Crown 2007 PF15690-7 Rev. 5/08
To Next Page
Loading...