LIFTING MECHANISM
Fork Inspection
340
M7.8-04.2-002
05 Rev. 11/08
Once the outside jaws are set, check to see if the inside
jaws of the calipers pass over the flanks of the fork
blade at any point between the end of the taper and the
heel of the fork blade. After checking the blade, re-
check the caliper setting by measuring the shank again
making sure the setting was not inadvertently changed.
Figure 16855-01
1 Fork Blade
2 Fork Shank
3 Measure Here to Set Outside Jaws
Figure 16856-01
1 Fork Shank Cross Section
Figure 16857-01
1 Fork Blade Cross Section
Crown 1988 PF7393-2 Rev. 11/08
To Next Page
Loading...