PLATFORM
Sideshifter
372
M9.0-1055-004
02 Rev. 7/07
3. Carefully mount sideshifter on truck carriage. Make
sure to engage the locator tab on the sideshifter
with the center notch on the truck's upper carriage
bar. Refer to Figure 16211.
4. Install lower hooks. Adjust as shown in Figure
16965 to ensure proper operation. Torque nuts
and cap screws to 165 Nm (1460 in lb).
5. Flush supply hoses thoroughly and install them.
6. Install forks (refer to Figure 16213).
7. Install backrest, refer to Figure 16214. Tighten
screws to 196 Nm (1726 in lb).
Figure 16211
Figure 16965
1 Locator Tab
2 Truck Upper Carriage Bar
3 Center Notch
(1)
Truck Lower Carriage Bar
(2)
Sideshifter
(3)
Lower Hook
(4)
Cap Screws
(5)
Nut
(6)
Clearance: 0.8 mm (0.031 in) Minimum
1.6 mm (0.063 in) Maximum
Figure 16213
Figure 16214
1 Backrest
2Cap Screw
3 Lockwasher
Crown 2007 PF15717-4 Rev. 7/07
To Next Page
Loading...