Edge-Core ECS4210-12P - Page 52

Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
– 52 –
Priority
213
Default Priority Sets the default priority for each port or trunk
213
Queue Sets queue mode for the switch; sets the service weight for each queue
that will use a weighted or hybrid mode
214
Trust Mode Selects IP Precedence, DSCP or CoS priority processing
220
DSCP to DSCP
221
Add Maps DSCP values in incoming packets to per-hop behavior and drop
precedence values for internal priority processing
221
Show Shows the DSCP to DSCP mapping list
221
CoS to DSCP
224
Add Maps CoS/CFI values in incoming packets to per-hop behavior and drop
precedence values for priority processing
224
Show Shows the CoS to DSCP mapping list
224
PHB to Queue
217
Add Maps internal per-hop behavior values to hardware queues
217
Show Shows the PHB to Queue mapping list
217
DiffServ
227
Configure Class
228
Add Creates a class map for a type of traffic
228
Show Shows configured class maps
228
Modify Modifies the name of a class map
228
Add Rule Configures the criteria used to classify ingress traffic
228
Show Rule Shows the traffic classification rules for a class map
228
Configure Policy
232
Add Creates a policy map to apply to multiple interfaces
232
Show Shows configured policy maps
232
Modify Modifies the name of a policy map
232
Add Rule Sets the boundary parameters used for monitoring inbound traffic, and
the action to take for conforming and non-conforming traffic
232
Show Rule Shows the rules used to enforce bandwidth policing for a policy map
232
Configure Interface Applies a policy map to an ingress port
241
VoIP Voice over IP
243
Configure Global Configures auto-detection of VoIP traffic, sets the Voice VLAN, and VLAN
aging time
244
Table 4: Switch Main Menu
(Continued)
Menu Description Page