Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 55 –
ACL Access Control Lists
290
Configure ACL
Show TCAM Shows utilization parameters for TCAM
294
Add Adds an ACL based on IP or MAC address filtering
295
Show Shows the name and type of configured ACLs
295
Add Rule Configures packet filtering based on IP or MAC addresses and other
packet attributes
295
Show Rule Shows the rules specified for an ACL
295
Configure Interface Binds a port to the specified ACL and time range
308
ARP Inspection
312
Configure General Enables inspection globally, configures validation of additional address
components, and sets the log rate for packet inspection
313
Configure VLAN Enables ARP inspection on specified VLANs
315
Configure Interface Sets the trust mode for ports, and sets the rate
limit for packet inspection
316
Show Information
Show Statistics Displays statistics on the inspection process
317
Show Log Shows the inspection log list
318
IP Filter
319
Add Sets IP addresses of clients allowed management access via the web,
SNMP, and Telnet
319
Show Shows the addresses to be allowed management access
319
Port Security Configures per port security, including status, response for security
breach, and maximum allowed MAC addresses
321
Port Authentication IEEE 802.1X
323
Configure Global Enables authentication and EAPOL pass-through
325
Configure Interface Sets authentication parameters for individual ports
Authenticator Sets port authenticator settings
326
Supplicant Sets port supplicant settings
330
Show Statistics Displays protocol statistics for the selected port
332
Authenticator Displays protocol statistics for port authenticator
332
Supplicant Displays protocol statistics for port supplicant
332
DoS Protection Protects against Denial-of-Service attacks
335
Table 4: Switch Main Menu
(Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General
