Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 56 –
IP Source Guard Filters IP traffic based on static entries in the IP Source Guard table, or
dynamic entries in the DHCP Snooping table
341
Port Configuration Enables IP source guard and selects filter type per port
341
Static Binding
343
Add Adds a static addresses to the source-guard binding table
343
Show Shows static addresses in the source-guard binding table
343
Dynamic Binding Displays the source-guard binding table for a selected interface
344
Administration
355
Log
355
System
355
Configure Global Stores error messages in local memory
355
Show Logs Shows logged error messages
355
Remote Configures the logging of messages to a remote logging process
358
LLDP
359
Configure Global Configures global LLDP timing parameters
360
Configure Interface
Configure General Sets the message transmission mode, enables SNMP notification, and
sets the LLDP attributes to advertise
361
Add CA-Type Specifies the location of the device attached to an interface
365
Show CA-Type Shows the location of the device attached to an interface
365
Modify CA-Type Modifies the location of the device attached to an interface
365
Show Local Device Information
367
General Displays general information about the local device
367
Port/Trunk Displays information about each interface
367
Show Remote Device Information
371
Port/Trunk Displays information about a remote device connected to a port on this
switch
371
Port/Trunk Details Displays detailed information about a remote device connected to this
switch
371
Show Device Statistics
379
General Displays statistics for all connected remote devices
379
Port/Trunk Displays statistics for remote devices on a selected port or trunk
379
Table 4: Switch Main Menu
(Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General
