Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 57 –
PoE
*
Power over Ethernet
381
Configure Global Displays the power budget for the switch
382
Configure Interface Configures port power parameters
383
SNMP Simple Network Management Protocol
385
Configure Global Enables SNMP agent status, and sets related trap functions
387
Configure Engine
388
Set Engine ID Sets the SNMP v3 engine ID on this switch
388
Add Remote Engine Sets the SNMP v3 engine ID for a remote device
389
Show Remote Engine Shows configured engine ID for remote devices
389
Configure View
390
Add View Adds an SNMP v3 view of the OID MIB
390
Show View Shows configured SNMP v3 views
390
Add OID Subtree Specifies a part of the subtree for the selected view
390
Show OID Subtree Shows the subtrees assigned to each view
390
Configure Group
393
Add Adds a group with access policies for assigned users
393
Show Shows configured groups and access policies
393
Configure User
Add Community Configures community strings and access mode
398
Show Community Shows community strings and access mode
398
Add SNMPv3 Local User Configures SNMPv3 users on this switch
399
Show SNMPv3 Local User Shows SNMPv3 users configured on this switch
399
Change SNMPv3 Local User Group Assign a local user to a new group
399
Add SNMPv3 Remote User Configures SNMPv3 users from a remote device
401
Show SNMPv3 Remote User Shows SNMPv3 users set from a remote device
401
Configure Trap
403
Add Configures trap managers to receive messages on key events that occur
this switch
403
Show Shows configured trap managers
403
Table 4: Switch Main Menu
(Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General
