Using the Equipment
To view this page, select the Preferences tab from the Program Transcoder page.
The factory default settings may be restored, i.e. overriding any entries made on this
page, by pressing the Reset to defaults button at the bottom of the page.
Figure 3.176 Program Transcoder Preferences Page
Display Defaults
• Service Order – Set the display of services on the Services tab in name or
service identifier order.
• Pid Format – Selects how the PID values are displayed; Hexadecimal or
Decimal.
• Video Output – Selects the video to be monitored. This should be left at None
as this is for future use only.
Audio Defaults
• Audio Language – Enables the selection, from a drop-down menu, of the
default audio language.
Video Defaults
• PCR Generation Interval – Sets the interval for generation of the PCR. If 0 is
entered then PCR generation is disabled (this is not recommended).
To Next Page
Loading...
