Removing the accessible drive cage
▶
Remove the front panel module, see "Removing the front panel module" on
page 465
.
▶
If applicable, remove all accessible drives, see "Removing an accessible
drive" on page 441.
▶
If applicable, remove an HDD extension box, see "HDD extension box" on
page 265.
Figure 345: Removing the accessible drive cage (A)
▶
Remove the two screws (see circles) from the bottom side of the server.
▶
Bring the server back to its horizontal position.
At least two people are needed to turn over a completely equipped
server. Remove HDDs and PSUs in order to facilitate the task.
Converting a floorstand model to a rack model
534 Upgrade and Maintenance Manual TX2550 M5
To Next Page
Loading...
