Table 89: Chassis Status LEDs in the QFX3600 and QFX3600-I Device
DescriptionStateColorName
The device is powered on.On steadilyGreenPower
A temperature or voltage error has been detected, and the device has shut
down. Power off the QFX3600 or QFX3600-I device following the
instructions in “Powering Off a QFX3600 Device” on page 412. Correct any
site temperature issues, and allow the device to cool down. Power on the
QFX3600 or QFX3600-I device and monitor the power supply and fan LEDs
to help determine where the error is occurring. If the amber Power LED
begins blinking again, power off the QFX3600 or QFX3600-I device and
contact customer support. See “Contacting Customer Support to Obtain a
Return Materials Authorization for a QFX Series Device or Component” on
page 619.
BlinkingAmber
Junos OS has been loaded on the device.On steadilyGreenStatus
The beacon feature has been enabled on the device using the request chassis
beacon command.
Intermittent
blinking
A software error has occurred. Power off the QFX3600 or QFX3600-I device
by following the instructions in “Powering Off a QFX3600 Device” on
page 412. Power on the QFX3600 or QFX3600-I device and monitor the
management board LEDs to ensure that Junos OS boots properly.
BlinkingAmber
The fan trays are operating normally.On steadilyGreenFan
An error has been detected in a fan tray installed on the rear panel of the
device. Replace the fan tray as soon as possible. To maintain proper airflow
through the chassis leave the fan tray installed in the chassis, until you are
ready to replace it.
BlinkingAmber
RELATED DOCUMENTATION
Front Panel of a QFX3600 Device | 48
Front Panel of a QFX3600-I Interconnect Device
Rear Panel of QFX3600 and QFX3600-I Devices
Chassis Alarm Messages on a QFX3500 Device | 632
519
To Next Page
Loading...
Need help?
General
