3. The software prompts you with the following option if you have a snapshot saved on the emergency
boot device:
Junos Snapshot Installer - (c) Juniper Networks 2013
Reboot
Install Junos Snapshot [14.1X53-D11_vjunos.61]
Boot to host shell [debug]
Select Install Junos Snapshot to install the snapshot.
The software prompts you with the following option if you have Junos OS software from the factory
installed on the emergency boot device.
Juniper Linux Installer - (c) Juniper Networks 2014
Reboot
Install Juniper Linux Platform
Boot to host shell [debug]
Select Install Juniper Linux Platform to install the Junos OS software from the emergency boot device.
4. The device copies the software from the emergency boot device, occasionally displaying status messages.
Copying the software can take up to 12 minutes.
When the software is finished being copied from the emergency device to the device, the device reboots
from the internal flash storage on which the software was just installed. When the reboot is complete,
the device displays the Junos OS login prompt:
root@switch#
5. Create a new configuration as you did when the device was shipped from the factory, or restore the
previously saved configuration file to the device.
6. Remove the emergency boot device.
585
To Next Page
Loading...
Need help?
General
