Interactive SourceMeter® Instrument Reference Manual Appendix D:
Model 2450 in a Model 2400 application
2450-901-01 Rev. B/September 2013 D-19
Model 2400 command
:SOURce[1]:CURRent:STOP?
:SOURce[1]:VOLTage:STOP
Model 2450 command
:SOURce[1]:SWEep:<function>:LINear (on page 6-81)
:SOURce[1]:SWEep:<function>:LINear:STEP (on page 6-83)
:SOURce[1]:SWEep:<function>:LIST (on page 6-85)
:SOURce[1]:SWEep:<function>:LOG (on page 6-87)
Notes
Sweep parameters are built into the sweep command path. See Sweep
operation (on page 3-51) for information.
Model 2400 command
:SOURce[1]:DELay?
Model 2450 command
:SOURce[1]:<function>:DELay (on page 6-66), where <function> is
CURRent or VOLTage.
:SOURce[1]:<function>:DELay?
Notes
When a delay is set, source auto delay is turned off.
Model 2400 command
:SOURce[1]:DELay:AUTO
:SOURce[1]:DELay:AUTO?
Model 2450 command
:SOURce[1]:<function>:DELay:AUTO (on page 6-67)
Notes
Model 2400 command
:SOURce[1]:FUNCtion[:MODE]
:SOURce[1]:FUNCtion[:MODE]?
Model 2450 command
:SOURce[1]:FUNCtion[:MODE] (on page 6-72)
:SOURce[1]:FUNCtion[:MODE]?
Notes
Model 2400 command
:SOURce[1]:LIST:CURRent
:SOURce[1]:LIST:CURRent?
Model 2450 command
:SOURce[1]:SWEep:<function>:LIST (on page 6-85)
Notes
In the Model 2450, this sets up a list of customer values for a sweep.
Model 2400 command
:SOURce[1]:LIST:CURRent:APPend
Model 2450 command
:SOURce[1]:SWEep:<function>:LIST (on page 6-85)
Notes
In the Model 2450, this setting is set as part of the configuration list that is
created by the sweep command.
Model 2400 command
:SOURce[1]:LIST:CURRent:POINts?
Model 2450 command
:SOURce[1]:SWEep:<function>:LIST (on page 6-85)
Notes
In the Model 2450, this setting is set as part of the configuration list that is
created by the sweep command.
Model 2400 command
:SOURce[1]:LIST:CURRent:STARt
:SOURce[1]:LIST:CURRent:STARt?
Model 2450 command
:SOURce[1]:SWEep:<function>:LIST (on page 6-85)
Notes
In the Model 2450, this setting is set as part of the configuration list that is
created by the sweep command.
To Next Page
Loading...
