TOS93 Series User’s Manual 173
Protective Conductor Current Test
Starting a Test
We recommend that you perform a pre-test inspection (p.281) before executing a test. For details on
connecting the power supply line for the product and EUT,
see “Connecting the EUT to the power supply”
(p.41).
Starting a test
1
Check that the product is correctly connected to the EUT.
2
Check that “READY” is shown on the display, and then press START.
“TEST” is shown in the upper right of the display, and the test starts.
If the test does not start, see “Unable to start a test”
(p.336).
WARNING
Risk of electric shock. When using the test leads, do not touch the tip of the lead with
your hand.
To Next Page
