258 User’s Manual TOS93 Series
System Settings
On the System Menu screen that appears when you press SYSTEM, you can change the CONFIG
settings and interface settings, view SCPI errors, set the clock, initialize and update the instrument, and
view the instrument information.
Displaying and Changing CONFIG Settings
You can display and change the following settings.
Item Description See
Power On Panel settings at startup.
p.259
Watchdog Turns the product off automatically when no SCPI communication takes place for
a given period.
p.260
Delay The duration of time until the product decides that there is no SCPI
communication when watchdog is enabled.
Screen Saver Screen saver starts.
p.261
Delay Time until the screen saver starts.
Key Key control lock.
p.262
Lock Level Range of key operations to lock.
Calibration Calibration settings.
p.263
DUE Sets the next calibration period.
Protection Keep Sets the operation that is performed when calibration period elapses.
Beeper Enables/disables the beep sound.
p.264
Key Beep sound for invalid operation.
Protection Beep sound for alarm occurrence.
SCPI Error Beep sound for SCPI errors.
Volume Pass Beep volume for pass judgment results.
Volume Fail Beep volume for fail judgment results.
Fail Mode Sets the instrument so that fail judgment results and PROTECTION mode cannot
be released from a device connected to the SIGNAL I/O connector or REMOTE
connector.
p.265
Double Action Tests can only be started by pressing and releasing STOP and then pressing
START within 0.5 seconds of releasing the STOP switch.
p.266
Momentary Tests are only executed while the START switch is held down.
p.266
Start Long Starts a test only when the START switch is held down for at least 1 second.
p.266
Pass Hold PASS judgment result hold time.
p.267
To Next Page
Loading...
