TOS93 Series User’s Manual 201
Meter Mode
Applicable models:
This section explains how to construct the measurement circuit, set measurement conditions, and execute
the measurement for leakage current (LC) meter mode.
Like typical multimeters, meter mode is used to measure and display the current and voltage across
terminals A an
d B. No judgment is made based on upper limit judgment or lower limit judgment reference
values.
The following flowchart shows the configuration and measurement steps.
9303LC
Execute a measurement
Set measurement conditions
Construct a measurement circuit
(p.203)
(p.212)
(p.212)
To Next Page
Loading...
