248 User’s Manual TOS93 Series
External Control
Using Option Products
Signal output from the STATUS OUT connector
The STATUS OUT connector on the rear panel outputs signals to the optional warning light unit (PL02-
TOS). Use Status Output (p.268) of CONFIG settings to set the signal output conditions.
For details on the PL02-TOS, see the “Warning Light PL02-TOS Operation Manual.”
Signal I/O of the REMOTE connector
You can control this product from the following option products using the REMOTE connector on the front
panel. For details on option products, see the operation manual for the option.
• Remote control box (RC01-TOS/RC
02-TOS)
• High voltage test probe (HP01A-
TOS/HP02A-TOS)
To Next Page
