2 User’s Manual TOS93 Series
Testing is not possible upon opening the package
When you first turn on this product after opening the package, the safety interlock will prevent
you from performing tests. Connect the included SIGNAL I/O plug to the SIGNAL I/O connector
to temporarily release the interlock (p. 239).
When you actually perform tests, design a system that uses the interlock for safety (p. 240).
Notes to the supervisor
• If the operators cannot understand the language used in this manual, translate the manuals
into the appropriate language.
• Make sure that the operators understand the information in this manual before they operate
this product.
• Keep this manual close to the product so that the operators can read the manual at any time.
You will receive a potentially fatal electric shock if:
• You touch an output terminal while output is being generated.
• You touch a test lead that is connected to an output terminal while output is being generated.
• You touch the EUT while output is being generated.
• You touch a location that is electrically connected to an output terminal while output is being
generated.
• You touch a location that is
electrically connected to an output terminal immediately after
output is turned off after a DC withstanding voltage test or insulation resistance test has been
performed.
DANGER
To Next Page
Loading...
