282 User’s Manual TOS93 Series
Maintenance | Inspection
Checking the EUT operation
The power supply line (AC LINE OUT on the rear panel) for the EUT normally outputs current only
during testing. To check the operation of the EUT before testing, set Line OUT to on to temporarily
run current from AC LINE OUT.
While Line OUT is on, you cannot start a test. In addition, is shown in the upper right of the
display.
1
Connecting the EUT (p.41).
2
On the Home menu screen, press Line OUT.
3
Press Line OUT to switch between on and off.
Line OUT switches between on and off each time you press the key.
This completes the setting.
To Next Page
Loading...
