Lexmark T650 Series - Page 54

2-18 Service Manual
4062
Go Back
Previous
Next
200.39 Sensor (input)
lingering jam
Source = Tray 3
Tray level = Empty
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
200.47 Sensor (input)
lingering jam
Source = Tray 4
Tray level = Not Low
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
200.48 Sensor (input)
lingering jam
Source = Tray 4
Tray level = Low
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
200.49 Sensor (input)
lingering jam
Source = Tray 4
Tray level = Empty
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
200.57 Sensor (input)
lingering jam
Source = Tray 5
Tray level = Not Low
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
200.58 Sensor (input)
lingering jam
Source = Tray 5
Tray level = Low
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
200.59 Sensor (input)
lingering jam
Source = Tray 5
Tray level = Empty
The media reached the sensor
(input) but did not clear it within
the specified time.
Go to sensor (input) lingering
jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-124.
201.00 Sensor (fuser output)
area jam.
Type 1 fuser
The media is jammed in the
sensor (fuser output) area.
Go to sensor (fuser output)
service check.
See “Sensor (fuser output)
service check” on
page 2-118.
201.01 Main drive motor
assembly load error.
Type 1 fuser
The main drive motor assembly
has failed or caused high
mechanical load due to paper
jam or bind.
1. Check all connections on
the main drive motor
assembly.
2. Check all connections on
the system card assembly.
3. Replace the main drive
motor assembly if problem
remains. Go to “Output
cover assembly removal”
on page 4-53.
Error
code or
message
Error contents Description/Action Possible repair actions