Lexmark T650 Series - Page 67

Diagnostic information 2-31
4062
Go Back
Previous
Next
203.08 Redrive motor load
error
The redrive motor assembly
has failed or caused high
mechanical load during the
warm up sequence.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor
assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal” on
page 4-62.
203.10 Redrive motor control
failure.
Media tray 1
The redrive motor does not
reach the proper operating
speed at the specified time.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor
assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal” on
page 4-62.
203.18 Redrive motor
assembly underspeed
error.
The redrive motor assembly
does not rotate at the specified
speed.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor
assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal” on
page 4-62.
203.20 Redrive motor lost
encoder failure
The redrive motor is not
reporting pulses back to the
engine.
1. Check all connections on
the redrive motor
assembly.
2. Check all connections on
the system card assembly.
3. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal” on
page 4-62
Error
code or
message
Error contents Description/Action Possible repair actions