............................................................................................................................................................
7
If desired, type and enter the quit command to exit the RC/V system.
Q
Result:
The RC/V session is terminated.
............................................................................................................................................................
8
Proceed to MCC page 118X,Y,X to restore GQPH pipe.
Request the status of the GQPH QPipe:
OP:STATUS,GQPHPIPE,QPIPE=a-b-c-d-e;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
Examine the output.
Restore the GQPHPIPE to the ACTIVE state
RST:GQPHQPIPE=a-b-c-d-e
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
For additional information, refer to the SIP Maintenance
Considerations procedure, Resolve GQPH QPipe Problems,
235-200-118.
............................................................................................................................................................
9
Stop. You have completed this procedure.
Assign QPH Pipe (RC/V 17.24)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-25
E ND OF S TEPS
.........................................................................................................................................................................................................................................................
To Next Page
Loading...
