EasyManua.ls Logo

Lucent Technologies 5ESS - Page 209

Lucent Technologies 5ESS
552 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
............................................................................................................................................................
6
On screen 2 of form 33.4, type and enter the parameters.
#GATEWAY IP ADDRESS 1 - Primary IP address of the
Ethernet-IP interface on the PH
#IP SUBNET MASK 1 - subnetwork mask associated with the
first gateway IP address
GATEWAY IP ADDRESS 2- secondary IP address of the
Ethernet-IP interface on the PH if the processor group to which
the PH belongs will be supporting an SCTP near endpoint; blank
if the PH will be supporting UDP paths
IP SUBNET MASK 2 - subnetwork mask associated with the
GATEWAY IP ADDRESS 2 (leave blank for UDP)
MTU SIZE - 1500
RATE - Rate associated with the speed of the Ethernet link
MODE - mode used for data flow of the Ethernet connection
............................................................................................................................................................
7
Type and enter the insert command.
I
Result:
Inserting...form inserted
NOTE: View MCC 118X,Y,X to see corresponding PH status
change to Active.
............................................................................................................................................................
8
Type and enter the previous screen command.
<
Result:
The INTERNET PROTOCOL VIEWS page is displayed.
............................................................................................................................................................
9
If desired, type and enter the quit command to exit the RC/V system.
Q
Result:
The RC/V session is terminated.
............................................................................................................................................................
10
Stop. You have completed this procedure.
Insert Ethernet - IP Interface (RC/V 33.4)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-43
E ND OF S TEPS
.........................................................................................................................................................................................................................................................

Table of Contents

Related product manuals