BKUP:ODD;
Result:
BKUP ODD COMPLETED
............................................................................................................................................................
7
Use OP:STATUS,SCTP,ASSOC to check the status of the new
association. It should be in the CLOSED MAN state.
It cannot be established until it has been added to an association set,
manually restored, and the far endpoint is in an INSERV state.
............................................................................................................................................................
8
Stop. You have completed this procedure.
Add New SCTP Association to Connect to a
SCTP Far Endpoint
Provisioning
....................................................................................................................................................................................................................................
5-104
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
E ND OF S TEPS
.........................................................................................................................................................................................................................................................
To Next Page
Loading...
