Lucent Technologies 5ESS - Page 487

d = GQPH channel group number
e = QLPS network number
The corresponding primary NLI serving the
ACT QLPS on QLPS
network
d is specified in the output. Only a single digit j (0 or 1) is
specified and actually
NLI a-j-k, where k is the ONTC side, could
serve GQPH Qpipe on the target QLPS network.
Access the NLI Summary page:
1200,X
Locate the NLI of interest and display the corresponding
DLI/NLI/TMSLNK SET page:
1201,Y
Determine if the NLI itself or the first associated TMSLNK is OOS.
If one is found, then refer to the Corrective Maintenance procedure,
Clear Network Link Interface Problems, 235-105-220, to repair the
NLI or TMSLNK.
After all QLPSs, QTMSLNKs and GSM NLIs on the target QLPS
network have been removed, did the associated QLPSs switch?
• If
yes, check the GQPH QPIPE status
OP:STATUS,GQPHQPIPE,QPIPE=a-b-c-d-e;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
If the resultant state is
OOS-QLPSLB or OOS-LVL1-FRAME,
CONTINUE this procedure for further recovery.
Otherwise, RETURN to Step 1 because the status of multiple
GQPH QPIPEs may have been affected by hardware
reconfigurations.
• If
no, attempt to conditionally switch QLPSs in the target
network
SW:QLPS=0-d;
If the switch is successful, then determine the status
OP:STATUS,GQPHQPIPE,QPIPE=a-b-c-d-e;
Where:
a = Global switch module number
Resolve GQPH QPipe Problems
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-51