Lucent Technologies 5ESS - Page 497

a = Global switch module number
b = SIP (Service type)
c = Interconnectivity status
• ACCESSIBLE = NGSMs become accessible.
• INACCESSIBLE = NGSMs become inaccessible.
d = Initial GMT loss/recovery timestamp
e = NGSMs impacted
This message reports that one or more NGSM-2000s have no GMT
connectivity to a particular GSM. This usually indicates that the GSM
is initializing.
Note: The NGSM-2000s in the message and list all the GQPH QPipes
for GSM:
OP:STATUS,GQPHPIPE,GSM=a;
Where:
a = Global switch module number
Result:
Note: The GQPH Qlinks for the particular QPipes and obtain the
status of the Qlinks for every NGSM-2000s:
OP:STATUS,GQPHLNK,GQPH=a-b-c-d;
Where:
a = Global module switch number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
Refer to the Output Messages Manual, 235-600-750, and take
appropriate actions.
............................................................................................................................................................
4
The following message indicates that one or more GQPH QPipes have
undergone recovery:
REPT GQPHPIPE RECOVERY GSM=x SERV=y
Where:
x = Global switch module number
Analyze General Message Transport (GMT)
Error Reports
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-61