214323 94 Revision B
Figure 3.109: Forward Position
Reposition the left reel arm cylinder as follows:
NOTE:
Reel components not shown in illustration for clarity.
9. Remove pin (A) securing cylinder (B) to bracket/light
assembly (C).
10. Remove bolts (D) securing bracket/light assembly (C) to the
reel arm, and remove the bracket/light assembly.
11. If necessary, remove the cable tie securing the harness to
bracket/light assembly (C) or the reel arm.
12. Swivel the light to the working position as shown.
Figure 3.110: Rearward Position
13. Reposition bracket/light assembly (C) on the reel arm as
shown, and secure with four bolts (D). Tighten bolts.
14. Push the reel back and attach cylinder (B) to bracket/light
assembly (C) with pin (A). Secure pin with cotter pin.
15. Secure the light harness to bracket/light assembly (C) using
a cable tie.
16. Check the reel clearance to the backsheet, upper cross
auger (if installed), and reel braces.
17. Adjust the reel tine pitch if necessary. Refer to 3.7.11 Reel
Tine Pitch, page 97.
OPERATION
To Next Page
Loading...
