Section
Summary of Change
Internal Use
Only
—
Deleted the empty title topic “Lubricating Header Drive Gearbox”
and promoted the procedures under it.
Technical
Publications
6.4.4 Changing Oil Filter, page
369
Updated filter number MD #183620 to kit MD #320360.
ECN 61432
6.8 Cutterbar, page 399 Topic heading “Cutterbar” was “Knife”. Technical
Publications
Adjusting Hold-Down Clips at
Double-Knife Center Pointed
Guard, page 412
Updated the center guard illustration. Technical
Publications
6.10.2 Checking and Adjusting
Feed Draper Tension, page 429
Added the word “Checking” to the title to reflect the procedure
content.
Product
Support
6.10.7 Checking Link Holder
Hooks, page 439
Added topic. Product
Support
6.12.2 Installing Side Drapers,
page 445
Added Step 1, page 445 to Step 5, page 445. Step 6, page 445 was
a NOTE.
Technical
Publications
7.2.5 Short Brace Kit For Center
Reel Arm, page 509
Added bundle information.
Technical
Publications
7.3.4 Vertical Knife Mounts,
page 512
• Replaced MD #B5757. with MD #B9048.
• Replaced MD #B6572 with MD #B9051.
• Updated Figure 7.10, page 512.
• Deleted NOTE about kit MD #5406 because the kit is
discontinued.
ECN 62429
ECN 57334
7.5.2 CA25 Combine Adapter
Feed Auger Flighting, page 515
Updated the bundle information: B6434 was B4829.
ECN 54793
7.5.5 Draper Clips, page 517
Added topic.
ECN 54224
ECN 58960
7.5.9 Upper Cross Auger, page
518
Updated all bundle numbers.
Engineering
9.3 Unloading and Assembly,
page 546
Corrected part numbers of the unloading and assembly manuals.
Technical
Publications
214323 iv Revision B
To Next Page
Loading...
