Matrix PRASAR UCS System Manual 97
Configuring System Pre-requisites
This displays the System resources (number of trunk and extension ports supported) of PRASAR UCS. It is quite
common for users to utilize the system resources below its capacity, especially when they begin using a new
system.
To make the task of configuring for such users easier, PRASAR UCS allows you to specify the number of trunks
and extension ports you want to configure. Accordingly all the relevant pages of Jeeves will show only as many
trunk and extension ports that you have specified, instead of showing all the ports supported by PRASAR UCS.
To be able to do this, you must configure the System Pre-requisites using Jeeves.
Defining System Pre-requisites using Jeeves
• Login as System Engineer.
• Under Configuration, click System Pre-requisites to open the page.
• Configure the following parameters:
• Customer Name: You can assign the name of the enterprise/organization that is using PRASAR UCS
as the Customer Name. The Customer Name may contain up to 80 characters. You may enter the
address of organization/enterprise along with the name.
The Customer Name you assign will appear on the various System Reports generated and printed by
the PRASAR UCS.
• Number of Ports Used: Define the number of ports to be used for each Port Type — SIP Extensions,
SIP Trunks in the respective boxes.
• Click Submit.
To Next Page
Loading...