Matrix PRASAR UCS - Incoming CLI Modification

922 Matrix PRASAR UCS System Manual
Incoming CLI Modification
118
What’s this?
For System users in countries, where the Calling Line Identification (CLI) received must be suitably modified before
it can be used to dial out the number, PRASAR UCS offers the feature ‘Incoming CLI Modification’.
The Incoming CLI received with the Country or Area Code, or both. However, the dialing pattern of the public
network may require the received CLI to be prefixed with additional digits, to dial out the same number. Or the
dialing pattern of the public network may require the CLI to be stripped off the prefixed digits to dial out the same
number.
With the feature ‘Incoming CLI Modification’ configured, the PRASAR UCS detects whether the incoming CLI is a
local number, a national, or an international number. It modifies the incoming CLI accordingly, by adding or stripping
off the prefixed digits so that the number can be dialed out as per the dialing pattern supported by the public
network.
The modified CLI is presented to the extension phones and is stored in the “Call Logs”, and SMDR (see “Station
Message Detail Recording (SMDR)”). Extension users can call a number in the Call Logs without having to modify
the CLI manually.
How it works
• Incoming CLI Modification parameters must be configured in the system considering the dialing pattern
supported by the local public network.
• Accordingly, PRASAR UCS matches the CLI received with the configured parameters.
• It detects whether it is an international, national or local number.
• It modifies the CLI according as per the Modification parameters configured.
• It presents the modified CLI to the extension; stores the modified CLI in the SMDR and in the Call Logs of
the extension.
• When the received CLI is dialed out by the extension user from Call Log, PRASAR UCS dials out the same
number.
How to configure
For this feature to work, Enable Incoming CLI Modification check box in “System Parameters” and Allow
Incoming CLI Modification check box in SIP trunk must be enabled. Refer “Configuring SIP Trunks” to know
more.
Configuring Incoming CLI Modification using Jeeves
• Login as System Engineer.
• Under Configuration, click System Parameters.
• Click Incoming CLI Modification to expand.
118. To comply with the Indian Government Laws and Regulation, this feature is not provided for India Region.