Matrix PRASAR UCS System Manual 1215
Message Notification
What’s this?
The VMS sets Message Wait on the extension, whenever a new message arrives in its personal Mailbox of the
extension. The VMS indicates the new message to the extension in the form of a Stuttered Dial Tone, if this is set
as the Type of Message Wait Indication for the extension. See “Message Wait” to know more.
How it works
• Extension A has Message Wait Indication type set as Stuttered Dial Tone.
• Whenever there is a new message in A’s mailbox, the system will play a Stuttered Dial Tone when A goes
off-hook.
• A must access the mailbox to listen to the new messages.
How to configure
To provide Message Notification to extensions, you must configure Message Wait Indication as Stuttered Dial
Tone for the extension. For detailed instructions, refer “Message Wait Settings” in “Extension Voice Mail Settings”.
How to use
• Go Off-hook, you will hear a Stuttered Dial Tone as Message Wait Indication.
• Access your mailbox.
• The VMS plays the message: “You have <n> new messages” followed by the prompt: “Enter your mailbox
password”.
• Dial your mailbox password, and follow VMS prompts.
To Next Page
Loading...